Sheet-Metal Garage Door Components
Source the individual metal parts that connect your garage door design. K-Display manufactures formed brackets, plates, and reinforcements to your drawings, with hole patterns, bend orientation, and finish coordinated for your assembly line.
Individual parts, ready for your assembly
A mounting plate can look right and still place its mating hardware in the wrong position. We review the formed part against your drawing references and the components it connects.
This scope covers separate fabricated parts. Door panel and section components address wider panel geometry; door subassemblies combine multiple parts into a defined delivered unit.
These are separate parts for an OEM assembly. The highlighted bracket face is an attachment interface; its location is defined by the finished-part drawing.
Parts for your production line
- Mounting plates
- Cut profiles and hole patterns for the mounting arrangement in your door design.
- Formed brackets
- Angles and offsets that position approved hardware relative to the door structure.
- Reinforcement parts
- Formed channels and backing plates for the locations and attachment method on your drawings.
- End and attachment plates
- Part-specific plates with the specified handedness and connection features.
Interfaces that determine fit
- Holes after forming
- Locate attachment holes from the datums that matter in the finished part, including holes across different faces.
- Mating hardware
- Identify the hardware and revision the part connects to. Visual similarity does not establish interchangeability.
- Left and right variants
- Separate mirrored geometry, bend direction, and part identification before production.
- Finish at connections
- Specify coated faces and any masking at mating surfaces, threads, or electrical bonding points.
Coordinate each formed-part variant
Cutting, bends and finish follow the finished-part references that locate your door hardware.
Review the formed geometry
Resolve bend directions, material callouts, and reference dimensions against the assembly context.
Make the part family
Coordinate cutting and forming for the approved geometry and variant quantities.
Deliver in the agreed state
Apply the specified finish and identify parts so your team can distinguish revisions and handed variants.
Make left and right parts unmistakable
Mirrored brackets can look alike while placing their attachment faces on opposite sides. The drawing looks at the door from inside the garage, with each identifier matched to its installed position. State the viewing direction so left and right stay consistent across part drawings and assembly instructions.
Place identification where the assembly team can read it before fastening, clear of holes and mating faces. The illustrated L and R marks show the principle; the actual identifiers, marking method, and location should follow the released part drawings.
Start with your current project package
Send the drawings and quantities you have. We can identify the remaining information needed to quote the work.
- Part and mating drawings
- Include revisions, material, critical dimensions, and the adjacent hardware geometry.
- Variants and volume
- List each hand or size, order quantities, and expected repeat demand.
- Finish and acceptance
- Share finish, masking, inspection, and packaging requirements.