Custom Equipment Chassis & Cabinets
Chassis and card cages, rack-mount enclosures, and server cabinets and rack frames, fabricated for indoor electronics and IT equipment.
Three pages, sorted by what the part carries
If the part holds boards, guides, and a backplane, or is an equipment box that never goes in a rack, it is Chassis & Card Cages. If it mounts in a 19-inch rack on ears or slides, it is Rack-Mount Enclosures. If it is the floor-standing frame with rails, doors, and panels that receives rack equipment, it is Server Cabinets & Rack Frames.
The chassis locates boards, the rack-mount box carries equipment between rails, and the rack frame receives those boxes. Each level is defined by the interface of the part it holds.
Chassis & Card Cages
Formed chassis, subracks, and card cages that carry boards and modules, with card guides, backplane rails, standoffs, and gasket lands fitted, delivered ready for boards.
Explore this product: Chassis & Card CagesRack-Mount Enclosures
19-inch rack-mount enclosures, shelves, rack ears, and brackets, on ears alone or with slides, with cutouts and hardware fitted.
Explore this product: Rack-Mount EnclosuresServer Cabinets & Rack Frames
Indoor equipment cabinets, open racks, and rack frames: welded or bolted frames with 19-inch rails, perforated or solid doors, side panels, and cable management.
Explore this product: Server Cabinets & Rack Frames
Signal and compute hardware here, power and control in Electrical Enclosures
Each level is set by the interface it meets: guide pitch and backplane rail inside a chassis, ears and rail holes on a rack-mount box, rails, doors, and base on a cabinet. Those positions have to survive forming, welding, and coating, so hardware, gasket lands, and bare bonding surfaces are planned into the part. Control panels, junction boxes, operator consoles, and outdoor equipment cabinets are in Electrical Enclosures.
Cutting, forming, welding, hardware, and powder coat happen in one shop. A cabinet frame, the box that mounts in it, and the chassis inside follow the same order: hardware goes in before coating, and bonding and ground surfaces are masked so they stay bare.
Tell us which of the three you’re building
Send the drawing or a sketch: rack units and hole style for a box or cabinet, board pitch and guide type for a chassis. We check the interfaces against what you send, then quote the part.
Request a quote